5mW 445nm-450nm BLUE LASER PEN (2)


5mW 445nm-450nm Blue Laser Pen (2), retail $29.95
Manufactured by: (Unknown) for Lilly Electronics (www.lillyelectronics.com)
Last updated 04-12-14





(In reference to the small packet that I received in the mail on the afternoon of 04-04-14:
{sung like the Foreigner song "Feels Like the First Time"}


The 5mW 445nm-450nm Blue Laser Pen (2) (hereinafter, probably just called a "blue portable laser" or even just a "blue laser") is a royal blue-emitting, directly-injected diode laser. That is, it produces deep blue laser radiation directly, without the need for messy, fragile nonlinear crystals like those green laser pointers and the amberish-yellow and slightly greenish-blue ones as well. It uses a pair of AAA cells to feed its laser diode with.

This laser has a measured power output of 12mW at 445.880nm in the blue part of the spectrum.

This is the reason I call it a "portable laser" or "laser pen" on this website instead of a "pointer". Lasers designated as "pointers" must -- by US law anyway -- have a power output that does not exceed 5mW.

It comes in a handsome aluminum body with a black matte finish and brushed chrome-colored accents.


 SIZE



To get the laser to turn on, first load it with two AAA cells (see directly below), and THEN you can go set fire to the dead wingless legless fly you found in your box of raisins
*...er...uh...go do some "scientifical" experiment or something.

Aim the laser well-away from your face first. Press & hold the chrome-colored button on the barrel to turn the death ray...er...uh...LASER on; release the button to neutralise it (deactivate it).


*This is Worm Quartet...one guy (Reverend Shoebox) and three worms.
The song "Find The Dead Wingless Legless Fly In Your Box Of Raisins" is from the album "Faster than a Speeding Mullet".



To change the batteries in your blue laser, unscrew the laser at the halfway point, throw the front portion in the {vulgar term for feces}bowl, yank that silver handle on the front of the cistern down, and flush it away...O WAIT!!! THAT'S THE GOOD PART!!! So just set it aside instead.

Tip the used AAA cells out of the barrel and into your hand, and dispose of or recycle them as you see fit.

Insert a pair of new AAA cells into the lower half of the barrel, nipple-end (+) positive first.
This is the opposite of how batteries are installed in most flashlights, so please pay attention to polarity here!

Screw the two halves back together, and be done with it.
Aren't you glad you didn't flush away that front half now?

Unable to measure current (amperage) due to the way this laser was constructed.



This is a self-contained laser , and not a flashlight meant to be carried around, thrashed, trashed, and abused - so I won't try to drown it in the toliet tank, bash it against a steel rod or against a concrete porch, let my mother's big dog's ghost, my kitty cat, or or my sister's kitty cats piddle (uranate) on it, run over it with a 450lb Quickie Pulse 6 motorised wheelchair, stomp on it, use a small or medium ball peen hammer in order to bash it open to check it for candiosity, fire it from the cannoñata, drop it down the top of Mt. Erupto (I guess I've been watching the TV program "Viva Piñata" too much again - candiosity is usually checked with a laser-type device on a platform with a large readout (located at Piñata Central {aka. "Party Central"}), with a handheld wand that Langston Lickatoad uses, or with a pack-of-cards-sized device that Fergy Fudgehog uses; the cannoñata (also located at Piñata Central) is only used to shoot piñatas to piñata parties away from picturesque Piñata Island, and Mt. Erupto is an active volcano on Piñata Island), send it to the Daystrom Institute for additional analysis, or perform other indecencies on it that a flashlight might have to have performed on it. So this section of the web page will be ***SIGNIFICANTLY*** more bare than this section of the web page on a page about a flashlight.

This is a directly-injected laser though (which by their very nature are more rugged than DPSS lasers!), who's active components are the inverter circuit, the laser diode, and the collimating lens. So it should withstand accidents better than a DPSS (diode pumped solid state) laser - the type of laser assembly found in deep red (671nm), yellow (593.5nm), green (532nm), and light blue (473nm) laser pointers. These lasers have several additional components (crystals, filters, etc.) in the optical train, and you can knock them out of alignment by doing little more than looking at them the wrong way. And if any of these components are knocked out of whack, you'll no longer get your deep red, yellow, green, or blue laser beam.
Though you still do not want to intentionally drop your blue-emitting portable laser because it's a precision optical instrument.

The biggest downside to this laser is the fact that while this is clearly a CDRH Class IIIb laser (making it somewhat dangerous!!!), there are no safety features at all that are normally required in Class IIIb lasers; e.g., there is no "emissions" indicator, no startup delay, no interlock of ANY type, and no mechanical beam shutter. This laser behaves like a Class IIIa laser pointer in this regard, which I believe is a rather severe no-no!!!

There is a duty cycle reccomendation for this laser: 45 seconds on and 15 seconds off for cooling.

Does this laser look awfully similar to this one?
Thought that you'd say so.
That's because they're identical, both physically and electrically (except for battery polarity), so I was able to use its evaluation as a template for this one.



Beam terminus photograph of this unique (well, "not-so-unique" now) laser on the target at 12".
Beam image bloomed quite a bit Those white and purple colors doe not actually exist.
"Not no way, not no how" as they say.



Beam terminus photograph on a wall at ~10'.
Again, that white color does not really exist, and beam image bloomed somewhat.


Power output measurement
Power output peaks at 12mW.


Power output measurement
Using known-new Energizer L92 lithium AAA cells.
Power output peaks at 16mW.

These tests were conducted on a LaserBee 2.5W USB Laser Power Meter w/Thermopile.



Spectrographic analysis
Spectrographic analysis of this laser.


Spectrographic analysis
Spectrographic analysis of this laser; spectrometer's response narrowed to a band between 442nm and 452nm to pinpoint wavelength, which is 445.880nm.

The raw spectrometer data (comma-delimited that can be loaded into Excel) is at http://ledmuseum.candlepower.us/45/445-10.txt


Spectrographic analysis
Spectrographic analysis of this laser while it was operating below lasing threshold.


Spectrographic analysis
Spectrographic analysis of this laser while it was operating below lasing threshold; spectrometer's response narrowed to a band between 440nm and 455nm to pinpoint peak wavelength, which is 447.650nm.

The raw spectrometer data (comma-delimited that can be loaded into Excel) is at http://ledmuseum.candlepower.us/45/445-10bt.txt

USB2000 Spectrometer graciously donated by P.L.


A beam cross-sectional analysis would normally appear here, but my poor defenseless helpless innocent ProMetric 8 Beam Cross-Sectional Analyser that I use for that test was destroyed by a nearby lightning strike in mid-July 2013.


In leiu of the beam cross-sectional analysis, I present this photograph of the laser's beam terminus with the beam widened by a lens.



TEST NOTES:
Test unit was purchased on Ebay on 03-22-14 (or "2014 22 Mar." or even "March 22, Twenty Stick-Pile of Broken Sticks" if you prefer) and was received on the afternoon of 04-04-14.


UPDATE: 00-00-00



PROS:
Color is very radiant & unusual for a pen-style handheld laser
The price is right!
Uses batteries that are common and relatively inexpen$ive
Color is very radiant an unu...o wait, I said that already!!!


NEUTRAL:



CONS:
No laser warning labelling of any type -- that's what nocked ½ star off its rating
No safety features required of a CDRH Class IIIb laser -- this is what lopped another ½ star off


    MANUFACTURER: Unknown
    PRODUCT TYPE: Blue-emitting diode laser pen
    LAMP TYPE: Unknown-type blue (450nm) laser diode
    No. OF LAMPS: 1
    BEAM TYPE: Very narrow spot
    SWITCH TYPE: Momentary pushbutton on/off button on barrel
    CASE MATERIAL: Aluminum
    BEZEL: Metal; laser & lens recessed into a hosel for them
    BATTERY: 2x AAA cells
    CURRENT CONSUMPTION: Unknown/unable to measure
    WATER- AND DIET DR. PEPPER-RESISTANT: Light splatter-resistant at maximum
    SUBMERSIBLE: ¡¡¡UN FANTASMA ESPANTOSO GRANDE QUE TOMA UNA MIERDA ENORME EN UNA CESTA DE DESECHO PLÁSTICA ESTO SE DESBORDA YA POR TOALLAS DE PAPEL SUCIAS, NO!!!
    ACCESSORIES: None
    SIZE: 156mm L x 13mm D
    WEIGHT: 70.70g (2.50 oz) incl. batteries
    COUNTRY OF MANUFACTURE: Not stated; but very likely China
    WARRANTY: Unknown/not stated

    PRODUCT RATING:

    Star Rating





5mW 445nm-450nm Blue Laser Pen (2) *







Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at ledmuseum@gmail.com.

Please visit this web page for contact information.

Unsolicited flashlights, LEDs, and other products appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.








This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.