FENIX P2D CE

Fenix P2D CE Flashlight, retail $55.00 (http://fenix-store.com...)
Manufactured by Fenix (www.fenixlight.com)
Last updated 04-23-07




The Fenix P2D CE is a small flashlight that has several intensity settings plus the SOS signal available with a single pushbutton on the tailcap and a bezel (head) that turns to set these modes.

It uses a Cree XLamp 7090 XR-E white LED, and is powered by a single lithium CR123A cell held in its all-aluminum body.


SIZE



Press the rubberised tailcap switch until it clicks and then release it to turn the P2D on in high mode ("turbo mode").
Repeat to turn the P2D off.

If you turn the flashlight off and immediately back on, it will strobe with a frequency of approximately 8Hz (8 flashes per second).

If you want to start the P2D in low mode, unscrew the bezel (head) approximately 1/8th of a turn before pressing the button. You'll see a very brief flash at maximum intensity and from that point on, the unit operates at minimum intensity.

When it's in minimum intensity mode, briefly turning the P2D off and quickly back on allows you to access two additional intensities and the SOS mode.

To quickly put the P2D in maximum intensity mode ("turbo mode") regardless of which mode you have it in (except fast strobe mode), just tighten the bezel (head) while keeping the light on.

If the unit is turned off for more than ~2 seconds, the modes will reset to default - turbo mode with the bezel tightened, and minimum intensity mode if the bezel is loosened.

This light is equipped with a LOTC (Lock Out TailCap). This ensures the P2D does not inadvertently activate when stored or packed in a box, suitcase, duffel bag, etc. for travel.
To activate the LOTC function, just loosen the tailcap approximately 1/2 of a turn.
To return the P2D to normal operating mode, just tighten the tailcap 1/2 of a turn or until it stops.

The flashlight comes with a nylon pouch/belt holster. The flashlight fits this holster bezel-up or bezel-down. This holster fits belts up to 1.5" wide. I do not own or use pants that require a belt however, so I cannot test this accessory in the manner in which it was intended to be used.



To change the battery, unscrew and remove the tailcap, gently place it on the ground, and kick it in the garden so the praying mantids will think it's something yummy to eat and subsequently strike at it...O WAIT!!! YOU'LL NEED THAT!!! So just set it aside instead.

Tip the old used-up CR123A cell out of the barrel, and dispose of or recycle it as you see fit.

Slide a new CR123A cell in the flashlight barrel, orienting it so the button-end (+) positive goes in first. Finally, screw the tailcap firmly back on.
Aren't you glad you didn't kick that tailcap into the garden with all those hungry, hungry praying mantids now?


Here is what a praying mantis looks like.
I found this guy on the morning of 09-08-06 clinging to the basket of my scooter.

Current usage ranges from 48.1mA on low to 346.2mA on turbo.




Photograph of the front end of this flashlight.

The flashlight appears to be reasonably sturdy. Ordinary flashlight accidents should not be enough to do it in. I administered the smack test on it (ten whacks against the concrete floor of a patio; five whacks against the side of the tailcap and five whacks against the side of the bezel), and found the expected damage. There is one *VERY SMALL* gouge on the side of the tailcap and another even smaller one on the side of the bezel where it was struck. These gouges are pinprick-sized; you almost need a magnifier to even see them. They might be considered "dents", not "gouges", as no bare metal was exposed. No optical or electrical malfunctions were detected.

The exterior finish is a Type III hard anodize ("HA-III" as us flashaholics know it), so it should stay new looking for longer, even if it goes up against keys, coins, or other flashlights during storage or transport.

The P2D is waterproof and submersible. When I removed the tailcap, relieved the flashlight of its battery, and performed that dreadful suction test on the barrel, no air leakage was detected. So if it falls into water, just shake it off and keep going. And if it falls next to the mailbox and the dog pisses on it, just douche it off with the garden hose or under the faucet - good as new.

There is an O-ring on the barrel that engages when the tailcap is screwed onto the barrel, and another O-ring on the barrel that engages when the bezel (head) is screwed on, so I don't think the P2D will leak from either of those locations.

No battery rattle can be detected whatsoever when the flashlight is turned on or off, regardless of how vigorously the unit is shaken.

The flashlight can be stood up on its tail on a dresser, counter, table, or other flat surface and beam onto the ceiling, acting like an electronic candle, even if the wrist lanyard is attached, because the holes for it are not on the bottom of the tailcap, but on the side.

The Fenix P2D has a glass window (or "lens" if you prefer) with an AR (antireflective) coating.

The tint of the light emitted is a pure, slightly cool white, with no red, pink, yellow, blue, purple, or "rotten porpoise urine green" coloration to it at all.

In my opinion, the SOS mode operates ***MUCH MORE SLOWLY*** than might be desired.
But in my opinion, so few users will actually *USE* the SOS mode that I will not derate the product because of this.

The dimming functions do not use PWM (Pulse Width Modulation), as no flickering is evident when the unit is waved about rapidly.






Beam photograph on the test target at 12".
That "rotten porpoise urine green" color you see in the photograph does not exist in reality.
Measures 120,000mcd (low) to 1,806,000mcd (high) on a Meterman LM631 light meter.



Beam photograph on a wall at ~10 feet.


Those rectangular graphic things near the top are marquees from:
Nintendo ''R-Type''
Super Tiger...er...uh...Konami ''Super Cobra''
Midway ''Omega Race''
Sega ''Star Trek''
Williams ''Joust''
Venture Line ''Looping''
Universal ''Mr. Do!'s Castle''
Jaleco ''Exerion''
Gremlin/Sega ''Astro Blaster''
Atari ''Tempest''
Gottlieb ''Q*bert''

upright coin-op arcade video games from the 1980s.


Spectrographic plot
Spectrometer plot of the LED in this flashlight.
Ocean Optics USB2000 Spectrometer on loan from WWW.TWO-CUBED.COM.


ProMetric analysis
Beam cross-sectional analysis.
Image made using the ProMetric System by Radiant Imaging.



TEST NOTES:
Test unit was sent by D.C. of www.fenix-store.com on 04-16-07, and it arrived on the afternoon of 04-20-07.



You can also buy the Fenix P2D flashlight in Canada from http://www.fenixtactical.com; same-day shipping is free whether you live in Canada or the United States.


UPDATE: 00-00-00



PROS:



CONS:



    MANUFACTURER: Fenix
    PRODUCT TYPE: Small handheld flashlight
    LAMP TYPE: Cree 7090 X RE LED
    No. OF LAMPS: 1
    BEAM TYPE: Medium spot with dimmer corona
    SWITCH TYPE: Press tailcap on/mode change/off; twist bezel mode change
    BEZEL: Metal; LED & reflector protected by glass window
    BATTERY: 1xCR123A cell
    CURRENT CONSUMPTION: 48.1mA to 346.2mA
    WATER RESISTANT: Yes
    SUBMERSIBLE: Yes, to shallow depths (~12") at minimum
    SIZE: 6.75cm L, 1.2cm D
    WEIGHT: 38.2g empty
    ACCESSORIES: 2 spare O-rings, belt holster, wrist lanyard, spare switch rubber
    WARRANTY: Lifetime

    PRODUCT RATING:

    Star Rating





Fenix P2D CE Flashlight * http://fenix-store.com...






Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at ledmuseum@gmail.com.

Please visit this web page for contact information.

Unsolicited flashlights appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.


WHITE 5500-6500K InGaN+phosphor 
ULTRAVIOLET 370-390nm GaN 
BLUE 430nm GaN+SiC
BLUE 450 and 473nm InGaN
BLUE Silicon Carbide
TURQUOISE 495-505nm InGaN
GREEN 525nm InGaN 
YELLOW-GREEN 555-575mn GaAsP & related
YELLOW 585-595nm
AMBER 595-605nm
ORANGE 605-620nm
ORANGISH-RED 620-635nm
RED 640-700nm
INFRARED 700-1300nm
True RGB Full Color LED
Spider (Pirrahna) LEDs
SMD LEDs
True violet (400-418nm) LEDs
Agilent Barracuda & Prometheus LEDs
Oddball & Miscellaneous LEDs
Programmable RGB LED modules / fixtures
Where to buy these LEDs 
Links to other LED-related websites
The World's First Virtual LED Museum
Legal horse puckey, etc.
RETURN TO OPENING/MAIN PAGE
LEDSaurus (on-site LED Mini Mart)



This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.