HUNTLIGHT FT-03XJA2

HuntLight FT-03XJA2, retail $40.00 (www.jsburlysflashlights.com...)
Manufactured by HuntLight (www.huntlight.net)
Last updated 04-09-07




The HuntLight FT-03XJA2 is a small LED flashlight that powers a white Seoul Semiconductor (SSC) P4 LED with a single AA cell housed in its barrel. It comes in an almost all-aluminum body, protected by a jet-black Type II anodized finish.

The LED is at the bottom of a mirror-smooth reflector, and the LED & reflector are protected by a glass window (or "lens" if you prefer, even though it does not modify the focus of the light in any manner).

This is the first flashlight that I have tested that is known to use a SSC P4 LED.


SIZE



To use the HuntLight FT-03XJA2, feed it a single AA cell first (see directly below), and then you can go paint the town red — or in this case, white.

Press the rubberised button on the tailcap firmly until it clicks and then release it to turn it on. Do the exact same thing to turn it off.

There is no momentary or signalling mode available when the flashlight is off, however, you can blink the HuntLight while it is on by partially depressing the tailcap button. If you don't mind the backward or reverse feeling of this, you can blink the flashlight this way.



To change the battery, unscrew and remove the tailcap, gently place it on the ground, and kick it into the garden so the hungry, hungry praying mantids will think it's something yummy to eat and subsequently strike at it...O WAIT!!! YOU'LL NEED THAT!!! So just set it aside instead.

Tip the used AA cell out of the barrel, and dispose of or recycle it as you see fit.

Slide a new AA cell in the flashlight barrel, orienting it so the button-end (+) positive goes in first. Finally, screw the tailcap back on.
Aren't you glad you didn't kick that tailcap into the garden with all those hungry praying mantids now?


Here is what a praying mantis looks like.
I found this guy on the morning of 09-08-06 clinging to the basket of my scooter.

Current usage measures 220.2mA on my DMM's 400mA scale.



The flashlight appears to be reasonably sturdy. Ordinary flashlight accidents should not be enough to do it in. I administered the smack test on it (ten whacks against the concrete floor of a patio; five whacks against the side of the tailcap and five whacks against the side of the bezel), and found the expected damage. There is some minor gouging to the bare Metaltamomon — er — the bare Metalguilmon — um that's not it either...the bare Metalpalmon...er...uh...wait a sec here...THE BARE METAL (guess I've been watching too much Digimon again! — now I'm just making {vulgar term for feces} up!!!) on the sides of the tailcap and bezel where it was struck. The light did go out after this test, but proper operation was restored after partially unscrewing the bezel (head) and then screwing it back on. I believe the anodizing on the threads was acting as an insulator; no damage was detected otherwise.

The exterior finish is a black Type II anodize (though the package indicates it has a Type III), so it should stay new looking for a fairly long time, even if it goes up against keys, coins, or other metal flashlights during storage or transport. I tried to cut through the HuntLight with the blade of a folding knife, and was successful. That's how I determined it has a Type II anodize.
Would I really try to cut up a brand spanken new flashlight?
You bet your sweet patootie I would, if it's in the name of science.

The front window ("lens") is made of glass, not plastic. It is AR (antireflective) coated; so more light gets out.

The FT-03XJA2 is waterproof but not submersible to any depths beyond several inches. When I removed the bezel, relieved the flashlight of its battery, and performed that dreadful suction test on the barrel, only very minor air leakage was detected. So if it falls into *SHALLOW* water, just shake it off and keep going. If it falls in the kitty litter box and the kitty pisses on it, just douche it off under the faucet — good as new. Just try not to dredge it in deeper water.

One of the first things I noticed was that the bezel is lightly scalloped; so if you set the HuntLight down face-first while it's on, some light leaks out of the scalloping so you can tell it's still turned on, and get that puppy shut down. Yes, I wasted a set of batteries in a SureFire KL2 by setting it on a dresser bezel-down without realising it was still switched on.

The flashlight can be stood up on its tail on a dresser, counter, table, or other flat surface and beam onto the ceiling, acting like an electronic candle.



Beam photograph on the test target at 12".
Measures 575,000mcd on a Meterman LM631 light meter.



Beam photograph on a wall at ~10 feet.

Those rectangular graphic things near the bottom are marquees from:
Midway ''Omega Race''
Sega ''Star Trek''
Williams ''Joust''
Venture Line ''Looping''
Universal ''Mr. Do!'s Castle''
Jaleco ''Exerion''
Gremlin/Sega ''Astro Blaster''
Atari ''Tempest''
Gottlieb ''Q*bert''

upright coin-op arcade video games from the 1980s.


Spectrographic plot
Spectrometer plot of the LED in this flashlight.
Ocean Optics USB2000 Spectrometer on loan from TWO-CUBED.


ProMetric analysis
Beam cross-sectional analysis.
Image made using the ProMetric System by Radiant Imaging.



TEST NOTES:
Test unit was sent by J.S.B. of J.S. Burly's on 04-07-07 and was received on the afternoon of 04-09-07.

Product was made in China. A product's country of origin really does matter to some people, which is why I published it on this web page.


UPDATE: 00-00-00



PROS:



CONS:



    MANUFACTURER: HuntLight
    PRODUCT TYPE: Small handheld flashlight
    LAMP TYPE: White SSC P4 LED
    No. OF LAMPS: 1
    BEAM TYPE: Medium spot w/ broad corona
    SWITCH TYPE: Tailcap button on/off
    CASE MATERIAL: Aluminum
    BEZEL: Metal; LED & reflector protected by glass window
    BATTERY: 1xAA cell
    CURRENT CONSUMPTION: 220.2mA
    WATER RESISTANT: Yes
    SUBMERSIBLE: Yes, to shallow depths *ONLY*
    ACCESSORIES: Wrist lanyard
    WARRANTY: Unknown/not stated

    PRODUCT RATING:

    Star Rating





HuntLight FT-03XJA2 * www.jsburlysflashlights.com...






Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at ledmuseum@gmail.com.

Please visit this web page for contact information.

Unsolicited flashlights appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.


WHITE 5500-6500K InGaN+phosphor 
ULTRAVIOLET 370-390nm GaN 
BLUE 430nm GaN+SiC
BLUE 450 and 473nm InGaN
BLUE Silicon Carbide
TURQUOISE 495-505nm InGaN
GREEN 525nm InGaN 
YELLOW-GREEN 555-575mn GaAsP & related
YELLOW 585-595nm
AMBER 595-605nm
ORANGE 605-620nm
ORANGISH-RED 620-635nm
RED 640-700nm
INFRARED 700-1300nm
True RGB Full Color LED
Spider (Pirrahna) LEDs
SMD LEDs
True violet (400-418nm) LEDs
Agilent Barracuda & Prometheus LEDs
Oddball & Miscellaneous LEDs
Programmable RGB LED modules / fixtures
Where to buy these LEDs 
Links to other LED-related websites
The World's First Virtual LED Museum
Legal horse puckey, etc.
RETURN TO OPENING/MAIN PAGE
LEDSaurus (on-site LED Mini Mart)



This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.