FENIX L2T

Fenix L2T, retail $44.95
(www.eliteled.com... or www.tadgear.com...)
Manufactured by Fenix (www.fenixlight.com)
Last updated 03-04-07




The Fenix L2T is a two-AA cell flashlight that has a white Luxeon III LED at the bottom of an almost-smooth reflector.

It comes in a thick aluminum body, and has an AR (antireflective) glass window in its "business-end" to protect the LED and reflector.

The L2T is turned on and off using a rubberised button on its tailcap. It is a two-stage light (high and low); these can be easily selected by turning the bezel.


SIZE



Feed your L2T first (see directly below), and then you can go paint the town red - or in this case, white.

Firmly press and release the button on the tailcap to turn the L2T on, and do the same thing again to turn it off.
Things just don't get much easier than this...well, not flashlights anyway.

This flashlight has two stages - high and low. To access them, just turn the bezel (head) clockwise a bit for high mode, and turn it counterclockwise a bit for low mode.

There is no momentary or signalling mode available when the flashlight is off, however, you can blink the flashlight while it is on by partially depressing the button. If you don't mind the backward or reverse feeling of this, you can blink the L2T this way.

A LOTC (Lock Out TailCap) is available; just unscrew the tailcap 1/8th to 1/4th of a turn, and the L2T will not turn on even if something actuates the switch during storage or transport.

The flashlight comes with a nylon pouch/belt holster. The flashlight fits this holster bezel-up or bezel-down. This holster fits belts up to 1.5" wide. I do not own or use pants that require a belt however, so I cannot test this accessory in the manner in which it was intended to be used.



To change the batteries, unscrew and remove the tailcap, gently place it on the ground, and kick it into the garden so the hungry, hungry praying mantids will think it's something yummy to eat and subsequently strike at it...O WAIT!!! YOU'LL NEED THAT!!! So just set it aside instead.

Tip the two used up old AA cells out of the barrel, and dispose of or recycle them as you see fit.

Slide two new AA cells in the flashlight barrel, orienting them so the button-end (+) positive goes in first. Finally, screw the tailcap firmly back on.
Aren't you glad you didn't kick that tailcap into the garden with all those hungry praying mantids now?

Current usage measures 126mA (low) and 693mA (high) on my DMM's 4A scale.




Photograph of the front of the L2T, showing the LED and reflector.

The flashlight appears to be reasonably sturdy. Ordinary flashlight accidents should not be enough to do it in. I administered the smack test on it (ten whacks against the concrete floor of a patio; five whacks against the side of the tailcap and five whacks against the side of the bezel), and found the expected damage. As with the Fenix L1T, there is one *VERY SMALL* gouge on the side of the tailcap where it was struck. This gouge is pinprick-sized; you almost need a magnifier to even see it. No optical or electrical malfunctions were detected.

(Update 07-23-06)
I ran over it with the rear drive wheels of a 450lb (with me in it) electric wheelchair on a concrete surface, and it wasn't phased by it. No optical or electrical malfunctions were detected.

The exterior finish is a Type III hard anodize ("HA-III" as us flashaholics know it), so it should stay new looking for longer, even if it goes up against keys, coins, or other flashlights during storage or transport.

The L2T is waterproof and submersible. When I removed the tailcap, relieved the flashlight of its batteries, and performed that dreadful suction test on the barrel, no air leakage was detected. I also tested the tailcap by unscrewing the bezel and suctioning the barrel, and no leakage was detected there either. So if it falls into water, just shake it off and keep going. If it falls next to the mailbox and the dog lifts his leg on it, just douche it off under the faucet - good as new.
There are O-rings on the barrel that engage when the tailcap or bezel are screwed on, so I don't think the L2T will leak there. Water, snow, pee, diet Pepsi, and other nasties stay outside where they belong. You can even throw it in the toilet bowl and nothing bad will happen to it.

The tint of the light emitted is a pure, slightly cool white, with no pink, yellow, blue, purple, or "rotten octopus urine green" coloration to it at all.

The unit will stand on its tail for use as an "electronic candle". It has been brought to my attention that *NOT EVERY* L2T can be stood on its tail because the switch protrudes a bit too far, but this is not the case with the unit I have.

Battery rattle is only evident when the unit is shaken somewhat vigorously; it does not occur during normal handling.

This page look an awful lot like the page for the Fenix L1T? You're right...I was able to use it as a template because the two products are reasonably similar.



Beam photograph on the test target at 12".
Measures 361,000mcd (low) and 1,009,000mcd (high).
Both measurements were taken on a Meterman LM631 light meter.


Spectrographic plot
Spectrometer plot of the LED in this flashlight.
Ocean Optics USB2000 Spectrometer on loan from TWO-CUBED.


ProMetric analysis
Beam cross-sectional analysis.
Image made using the ProMetric System by Radiant Imaging.




Beam photograph on a wall at ~15'.
That red star thing on the wall is from an American DJ Laser Widow.



TEST NOTES:
Test unit was sent by G.L. of eliteled.com on 05-08-06, and it arrived here on 05-27-06.


UPDATE: 06-30-06
A second sample was sent by Patrick of www.tadgear.com and was received on 06-30-06.


UPDATE: 10-07-06
All our products being sold at the time being are not reverse-polarity protected. If the batteries are installed incorrectly, the circuit might be damaged. Though the rate is very low, we do need to install the batteries carefully.


PROS:



CONS:



    MANUFACTURER: Fenix
    PRODUCT TYPE: Small handheld flashlight
    LAMP TYPE: White Luxeon III LED
    No. OF LAMPS: 1
    BEAM TYPE: Medium spot with dimmer corona
    SWITCH TYPE: Pushbutton on/off on tailcap
    BEZEL: Metal; LED & reflector protected by an AR glass window
    BATTERY: 2xAA cells
    CURRENT CONSUMPTION: 126mA and 693mA
    WATER RESISTANT: Yes
    SUBMERSIBLE: Yes, to shallow depths (~12") at minimum
    ACCESSORIES: Nylon holster, wrist lanyard, O-ring, switch rubber
    WARRANTY: Lifetime

    PRODUCT RATING:

    Star Rating





Fenix L2T * www.fenixlight.com






Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at ledmuseum@gmail.com.

Please visit this web page for contact information.

Unsolicited flashlights appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.


WHITE 5500-6500K InGaN+phosphor 
ULTRAVIOLET 370-390nm GaN 
BLUE 430nm GaN+SiC
BLUE 450 and 473nm InGaN
BLUE Silicon Carbide
TURQUOISE 495-505nm InGaN
GREEN 525nm InGaN 
YELLOW-GREEN 555-575mn GaAsP & related
YELLOW 585-595nm
AMBER 595-605nm
ORANGE 605-620nm
ORANGISH-RED 620-635nm
RED 640-700nm
INFRARED 700-1300nm
True RGB Full Color LED
Spider (Pirrahna) LEDs
SMD LEDs
True violet (400-418nm) LEDs
Agilent Barracuda & Prometheus LEDs
Oddball & Miscellaneous LEDs
Programmable RGB LED modules / fixtures
Where to buy these LEDs 
Links to other LED-related websites
The World's First Virtual LED Museum
Legal horse puckey, etc.
RETURN TO OPENING/MAIN PAGE
LEDSaurus (on-site LED Mini Mart)



This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.