CROSS GENERATOR
LASER DIODE MODULE



Cross Generator Laser Diode Module, retail $15.00 (www.mfgcn.com)
Manufactured by (Unknown) for AixiZ Service and International LLC (www.mfgcn.com)
Last updated 08-09-09





(In reference to the envelope I received in the mail on the afternoon of 08-28-06):
{sung like the Foreigner song "Feels Like the First Time"}
Feels like a flaaaaaash-liiiight...feels like a FLAAAA-aaaash-liiiight!!!
Feels like a flaaaaaash-liiiight...feels like a FL

BREAK IN 50960
READY.
CONT

?UNDEF'D STATEMENT ERROR IN 64738
READY.

Let's try that again...as soon as I opened the envelope, I *knew* it wasn't a flashlight...

Feels like a laaaaaa-sssser...feels like a LAAAAA-aaaaa-ssser!!!
Feels like a laaaaaa-sssser...feels like a LAAAAA-aaaaa-ssser!!!

This is a small, pre-wired red diode laser module that has a cross generator lens built in. It's ready to connect to any source of 3 volts to 3.2 volts DC that you happen to have handy; whether that's a pair of 1.5 volt AAA or AA cells, a 3 volt lithium CR2 or CR123A cell, or a "wall wart" type AC adapter that you know has an output of 3 to 3.2 volts DC and can deliver at least 40mA.
It comes prepped with power wires, approximately 4.5" (~10cm) in length.

The laser module is ready to go as soon as you receive it.


 SIZE



To use the laser module, just connect it to any source of 3.0 to 3.2 volts DC via the included wires. Red is (+) positive, black is (-) negative.

There is no on/off switch; if you wish to use one you will have to supply and connect it yourself. Connect the switch in series with the laser; hook up one lead to the laser's red wire; connect the other to the power supply (+) positive.

The cross generator lens is adjustable for focus; simply turn the front bezel of the laser module one way or the other until the focus is where you want it. A spring inside helps to keep the lens at the focus you set it at; if this spring were to be removed or become lost, the lens assembly would freewheel quite easily.



Because this device runs from any source of 3 to 3.2 volts DC, this section will contain very little additional information.

Current consumption measures 39.71mA at a Vf of 3.01 volts



Because this is a component designed to be installed in something, and not a flashlight, I will not beat it against the concrete floor of a patio or a steel rod, stomp on it, try to drown it in the crapper, run over it, or bestow upon it other misfortunes that may be bestowed upon flashlights, so this section of its web page will be relatively bare.

This unit projects a sharp, very well-defined cross. This is because it actually uses a lens assembly, not a holographic film found in those pattern projecting laser pointers you often see being sold for under $2.00 in "dollar stores" and on Ebay.

As I mentioned earlier, the cross generator lens is adjustable for focus; simply turn it one way or the other until the focus is where you want it. This allows you to use the cross generator module close to your target or far away from it.



Beam photograph on the test target at 18".
Measures 3.024mW on a laser power meter.

Color is not yellow as shown in this photograph.


Spectrographic plot
Spectrographic analysis of this laser module.


Spectrographic plot
Same as above; newer spectrometer software & settings used.


Spectrographic plot
Same as above; spectrometer's response narrowed to a band between 630nm and 650nm to pinpoint wavelength.
USB2000 spectrometer graciously donated by P.L.



TEST NOTES:
Test unit was purchased on Ebay on 08-14-06, and was received on 08-28-06.


UPDATE: 09-07-06
I have decided to rate this product five full stars and place it in The Trophy Case on this website.


PROS:
Labelled properly for power & wavelength
Cross is clean with no unwanted speckling or other artifacts
Uses an optic, not a holographic grating for pattern generation


CONS:
Not waterproof or submersible; but most lasers aren't. Will not affect rating.


    MANUFACTURER: Unknown
    PRODUCT TYPE: Laser module w/cross generating lens
    LAMP TYPE: Red laser diode, 635nm
    No. OF LAMPS: 1
    BEAM TYPE: High divergence cross shape; focus is somewhat adjustable
    SWITCH TYPE: N/A
    BEZEL: Metal
    BATTERY: N/A
    CURRENT CONSUMPTION: 39.71mA
    WATER RESISTANT: No
    SUBMERSIBLE: No
    ACCESSORIES: None
    WARRANTY: Only warranted against DOA

    PRODUCT RATING:

    Star Rating





Cross Generator Laser Diode Module * www.mfgcn.com







Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at ledmuseum@gmail.com.

Please visit this web page for contact information.

Unsolicited flashlights, LEDs, and other products appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.



WHITE 5500-6500K InGaN+phosphor 
ULTRAVIOLET 370-390nm GaN 
BLUE 430nm GaN+SiC
BLUE 450 and 473nm InGaN
BLUE Silicon Carbide
TURQUOISE 495-505nm InGaN
GREEN 525nm InGaN 
YELLOW-GREEN 555-575mn GaAsP & related
YELLOW 585-595nm
AMBER 595-605nm
ORANGE 605-620nm
ORANGISH-RED 620-635nm
RED 640-700nm
INFRARED 700-1300nm
True RGB Full Color LED
Spider (Pirrahna) LEDs
SMD LEDs
True violet (400-418nm) LEDs
Agilent Barracuda & Prometheus LEDs
Oddball & Miscellaneous LEDs
Programmable RGB LED modules / fixtures
Where to buy these LEDs 
Links to other LED-related websites
The World's First Virtual LED Museum
Legal horse puckey, etc.
RETURN TO OPENING/MAIN PAGE
LEDSaurus (on-site LED Mini Mart)



This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.