PALM BLAZE (2) K2
LUXEON LED FLASHLIGHT

Palm Blaze (2) K2 Luxeon LED Flashlight, retail $44.95 (http://store.advancedmart.com...)
Manufactured by (Unknown)
Last updated 07-07-07




This is a good looking, nice feeling 3xC cell Luxeon K2 LED flashlight in an almost all aluminum case. The only non-metal parts visible from the outside are the rubberised pushbutton on/off switch, and the optic of the Luxeon LED.

It features two light levels (high and low), and a blinking mode that is easily accessible regardless of which mode the flashlight is in (high, low, or off) when you wish to use it.

Speaking of the Luxeon K2 LED, it's using what I believe is a Fraen collimator. This optic produces a relatively tight beam with a mainly square configuration (a circular centeral hotspot with a square corona).


SIZE



To use the flashlight, install three C cells (not included) first (see the "Feeding Time" section directly below), and then you can go to town.

Press the rubbery button on the barrel gently until it clicks and then release it to turn it on high.

Press the and release the button again to turn it on low.

Finally, press and release the button the same way again to turn the flashlight off.

To access the blinking mode, press and hold the button down for four seconds, then release it. This mode is accessible regardless of what mode the flashlight is in at the moment.

There is no momentary or signalling mode available in this flashlight, so please don't look for or expect to find one.

The light can be turned off from any mode with a single press of the button after ~3 seconds - no need to cycle through low mode.


The flashlight comes with a nylon pouch/belt holster. The flashlight fits this holster bezel-up; a flap with a hook-and-loop fastener on it folds over the top and attaches to the body of the holster, so the flashlight doesn't just fall out. This holster fits belts up to 1.5" wide, and is threaded through the belt. I do not own or use pants that require a belt however, so I cannot test this accessory in the manner in which it was intended to be used.



To change the batteries, unscrew and remove the tailcap, gently place it on the ground, and kick it into the garden so the hungry, hungry praying mantids will think it's something yummy for their tummies and subsequently strike at it...O WAIT!!! YOU'LL NEED THAT!!! So just set it aside instead.

Tip the used C cells out of the barrel, and dispose of or recycle them as you see fit.

Slide three new C cells in the flashlight barrel, orienting them so the button-end (+) positive goes in first. Finally, screw the tailcap back on.
Aren't you glad you didn't kick that tailcap into the garden with all those hungry praying mantids now?


Here is what a praying mantis looks like.
I found this guy on the morning of 09-08-06 clinging to the basket of my scooter.

Current usage measures 343mA (low) and 2,001mA (2.001 amps) (high) on my DMM's 4A scale.




Photograph of the front of this flashlight, showing the optic.
Note the circular hole in the center.

I beat the living tweedle out of it (gave it ten firm whacks against the concrete floor of a patio; five whacks against the side of the tailpiece and five whacks against the side of the bezel), and found the expected damage. There is some VERY MINOR gouging to the bare Metalpalmon - er - the bare Metalvenommyotismon - um that's not it either...the bare Metalwargrowlmon...mmm...the bare Metalbeetlemon...uh...wait a sec here...THE BARE METAL (guess I've been watching too much Digimon again! Now I'm just making {vulgar term for crapola} up! ) on the side of the tailpiece and bezel where it was struck. No optical or electrical malfunctions were detected. It still works as well now as it did when I received it earlier this afternoon.

The flashlight appears to be weather- and water-resistant at the very least, despite there being a hole in the optic. When I removed the tailcap, relieved the barrel of its batteries, and then performed that dreadful suction test, only very slight leakage was detected. So if it fell into shallow water, just shake it off and keep going. And you need not be concerned about using it in rain or snow. And if it fell in the litterbox and the kitty cat pissed on it, just take the garden hose to it or douche it off under the faucet...good as new!

The light produced is a pure white, with no obvious red, pink, yellow, blue, purple, or "rotten jackass urine green" tints to it.

This evaluation look spookily similar to the Palm Blaze (1) K2 Luxeon LED Flashlight?
Thought you'd say so...I used its page as a template for this one.



Beam photograph on the test target at 12".
Measures 550,000mcd (low) and 3,110,000mcd (high) on a Meterman LM631 light meter.



Beam photograph on a wall at ~10 feet; without photoflash.



Beam photograph on a wall at ~10 feet; photoflash was used.

Those rectangular graphic things near the center of these photographs are marquees from:
Nintendo ''R-Type''
Super Tiger...er...uh...Konami ''Super Cobra''
Midway ''Omega Race''
Sega ''Star Trek''
Williams ''Joust''
Venture Line ''Looping''
Universal ''Mr. Do!'s Castle''
Jaleco ''Exerion''
Gremlin/Sega ''Astro Blaster''
Atari ''Tempest''
Gottlieb ''Q*bert''

upright coin-op arcade video games from the 1980s.

And that graphic toward the right is:
A "BIG SCARY LASER" poster sent by www.megagreen.co.uk




Beam photograph on a ceiling at ~5 feet; showing the square beam.


Spectrographic plot
Spectrometer plot of the LED in this flashlight.
Ocean Optics USB2000 Spectrometer on loan from WWW.TWO-CUBED.COM.


ProMetric analysis
Beam cross-sectional analysis.
Image made using the ProMetric System by Radiant Imaging.






TEST NOTES:
Test unit was sent by J.W. of AdvancedMart, and was received on the afternoon of 06-28-07.


UPDATE: 00-00-00



PROS:



CONS:



    MANUFACTURER: Unknown
    PRODUCT TYPE: Handheld LED flashlight
    LAMP TYPE: White Luxeon K2 LED
    No. OF LAMPS: 1
    BEAM TYPE: Medium spot; relatively square configuration
    SWITCH TYPE: Rubberised pushbutton high/low/off on barrel
    CASE MATERIAL: Aluminum
    BEZEL: Metal; unprotected acrylic optic
    BATTERY: 3xC cells
    CURRENT CONSUMPTION: 343mA (low) and 2,001mA (high)
    WATER RESISTANT: Yes
    SUBMERSIBLE: No
    ACCESSORIES: Holster, wrist lanyard
    WARRANTY: 90 days

    PRODUCT RATING:

    Star Rating





Palm Blaze (2) K2 Luxeon LED Flashlight * http://store.advancedmart.com...






Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at ledmuseum@gmail.com.

Please visit this web page for contact information.

Unsolicited flashlights appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.


WHITE 5500-6500K InGaN+phosphor 
ULTRAVIOLET 370-390nm GaN 
BLUE 430nm GaN+SiC
BLUE 450 and 473nm InGaN
BLUE Silicon Carbide
TURQUOISE 495-505nm InGaN
GREEN 525nm InGaN 
YELLOW-GREEN 555-575mn GaAsP & related
YELLOW 585-595nm
AMBER 595-605nm
ORANGE 605-620nm
ORANGISH-RED 620-635nm
RED 640-700nm
INFRARED 700-1300nm
True RGB Full Color LED
Spider (Pirrahna) LEDs
SMD LEDs
True violet (400-418nm) LEDs
Agilent Barracuda & Prometheus LEDs
Oddball & Miscellaneous LEDs
Programmable RGB LED modules / fixtures
Where to buy these LEDs 
Links to other LED-related websites
The World's First Virtual LED Museum
Legal horse puckey, etc.
RETURN TO OPENING/MAIN PAGE
LEDSaurus (on-site LED Mini Mart)



This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.