ULTIMATE STROBE LIGHT (2)



Ultimate Strobe Light (2), retail $4.99 ()
Manufactured by (Unknown) for Pumpkin MastersŪ (www.pumpkinmasters.com)
Last updated 10-15-12





The Ultimate Strobe Light (2) really isn't a "STROBE light" in the truest sense of the word, but it is a nifty light designed to be used instead of candles in a Jack-O-Lantern (carved pumpkin) that causes the insides to flash in a spooky manner.

It comes in a shiny, chrome-like plastic case, and has three white LEDs that are responsible for the spooky lighting effects.

The whole rig feeds from two AAA cells that you supply yourself.

Unlike candles, there is no smoke, soot, melted wax, or fire hazard to worry about.


 Size of product w/hand to show scale SIZE



To use the Ultimate Strobe Light (2), feed it first (see directly below), and THEN you can go and relax the embouchure
* - er - uh - I mean - make a Jack-O-Lantern all spooky and scary and frightening and stuff .

On the upper surface of the unit, you'll see a small circular button.
Press & release the button, and place the Ultimate Strobe Light (2) inside a Jack-O-Lantern where you might otherwise place a candle.

Press & release the button to neutralise the unit (turn it off) when finished using the product.



To change the batteries in the Ultimate Strobe Light (2), unscrew the small Phillips screw, remove the battery door from the underside of the unit, and throw them into the graveyard so the zombies find them, drop them into an open grave, and take a leak on them...O WAIT!!! YOU'LL NEED THOSE!!! So just set them aside instead.

If necessary, remove the used AAA cells from the compartment, and recycle or dispose of them as you see fit.

Install two new AAA cells into the compartment, orienting each one so its flat-end (-) negative faces a spring for it in each chamber.

Place the battery door back on, screw that screw back in, and be done with it.
Aren't you glad you didn't throw that battery door & screw into the graveyard with all those smelly, rotting, yucky zombies with full pissinary bladders now?



This is a Halloween light for use inside a Jack O Lantern, not a flashlight designed to be carried around, thrashed, trashed, and abused. So I won't throw it against the wall, stomp on it, try to drown it in the toliet bowl or the cistern, run over it, swing it against the concrete floor of an outdoor patio, use a small ball peen hammer in order to bash it open to check it for candiosity, fire it from the cannoņata, drop it down the top of Mt. Erupto (I guess I've been watching the TV program "Viva Piņata" too much again - candiosity is usually checked with a laser-type device on a platform with a large readout (located at Piņata Central), with a handheld wand that Langston Lickatoad uses, or with a pack-of-cards-sized device that Fergy Fudgehog uses; the cannoņata (also located at Piņata Central) is only used to shoot piņatas to piņata parties away from picturesque Piņata Island, and Mt. Erupto is an active volcano on Piņata Island {In the episode "Les Saves the Day...Again", Paulie Preztail says "Hey, ever wonder why this park's called 'Mount Erupto' anyway?", then Franklin Fizzlybear says "I think its an old native term. Means 'very safe.'"}), send it to the Daystrom Institute for additional analysis, or inflict upon it punishments that flashlights (that were born to be flashlights and nothing but flashlights) may have inflicted upon them.

If it fell in water and you suspect it got flooded, disassemble it as you would for a battery change, dump out the water if necessary, and set the parts in a warm dry place for a couple of days or so just to be sure it's completely dry inside before you reassemble and use it again.

If it fell into seawater, got thrown into a glass of milk, if it fell in a root beer float, if somebody squirted a Massengill brand post-menstrual disposable douche or a Fleet brand disposable enema at it (and hit it with the douche or the enema), or if somebody or something peed on it, rinse all the parts out with fresh water before setting them out to dry. You don't want your Ultimate Strobe Light (2) to smell like seaweed, sour milk, flowers, fresh butts, or rotten piss when you go to use it next. Besides, salt (from seawater, disposable douches, disposable enemas, or uranation), lactic acid (from moo juice), glycerol (from antifreeze), or sugar (from root beer & ice cream) can't be very good for the insides.

So this section of the Ultimate Strobe Light (2)'s evaluation will appear SIGNIFICANTLY more bare than this section of the web page on a page about a flashlight.

There is a warning on the packaging materials that states the following:

CAUTION: Choking hazard. May contain small parts. Not for children under 3 years of age.

Does this evaluation look an awful lot like the one I made for this product?
Thought you'd say so.
They apparently differ only by name and case color, so I could use its eval. as a template for this one.



Photograph of the product's beam terminus on the test target at ~12".


Spectrographic analysis
Spectrographic analysis of the white LEDs in this product.


Spectrographic analysis
Spectrographic analysis of the white LEDs in this product; spectrometer's response narrowed to a band between 420nm and 450nm to pinpoint native emission peak wavelength, which is 436.770nm.

USB2000 spectrometer graciously donated by P.L.



Video on YourTube showing nothing more than the strobing effect of the Lightning Strobe Light.
We don't yet have a Jack-O-Lantern (carved pumkin) primarily because it's too early for Halloween so I cannot show it being used in one.

This video is approximately 54.0421672679 megabytes (54,535,706 bytes) in length; dial-up users please be aware.
It will take no less than two hundred seventy minutes to load at 48.0Kbps.

IMPORTANT!!! This video is of my Lightning Strobe Light, which I chose to use since these two products are optically and electrically identical.





TEST NOTES:
Test unit was purchased at a Safeway store in Federal Way WA. USA on 10-11-12.

* From the Star Trek: TNG episode "Future Imperfect".


UPDATE: 00-00-00



    MANUFACTURER: (Unknown) for Pumpkin MastersŪ
    PRODUCT TYPE: Replacement "candle" for Jack-O-Lanterns
    LAMP TYPE: 5mm white LED
    No. OF LAMPS: 3
    BEAM TYPE:
    SWITCH TYPE: Pushbutton on/off on upper surface of product
    CASE MATERIAL: Plastic
    BEZEL: Plastic; LEDs recessed into concave "dome" for them
    BATTERY: 2x AAA cells
    CURRENT CONSUMPTION:
    WATER- AND URANATION-RESISTANT: Light water-resistance (it's designed to go inside of a damp pumpkin!)
    SUBMERSIBLE: IL DIAVOLO INDOSSA UN PANNOLINO PIENO DI MERDA, NO!
    ACCESSORIES: None
    SIZE: 76.50mm Dia. x 27mm H
    WEIGHT: 55.50g (1.960 oz.) with batteries
    COUNTRY OF MANUFACTURE: China
    WARRANTY:

    PRODUCT RATING:

    This is a seasonal novelty product (it is intended to replace the candle in a Jack O'Lantern) and will not be assigned a "star" rating for that reason.





Ultimate Strobe Light (2) *







Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at ledmuseum@gmail.com.

Please visit this web page for contact information.

Unsolicited flashlights, LEDs, and other products appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.



WHITE 5500-6500K InGaN+phosphor 
ULTRAVIOLET 370-390nm GaN 
BLUE 430nm GaN+SiC
BLUE 450 and 473nm InGaN
BLUE Silicon Carbide
TURQUOISE 495-505nm InGaN
GREEN 525nm InGaN 
YELLOW-GREEN 555-575mn GaAsP & related
YELLOW 585-595nm
AMBER 595-605nm
ORANGE 605-620nm
ORANGISH-RED 620-635nm
RED 640-700nm
INFRARED 700-1300nm
True RGB Full Color LED
Spider (Pirrahna) LEDs
SMD LEDs
True violet (400-418nm) LEDs
Agilent Barracuda & Prometheus LEDs
Oddball & Miscellaneous LEDs
Programmable RGB LED modules / fixtures
Where to buy these LEDs 
Links to other LED-related websites
The World's First Virtual LED Museum
Legal horse puckey, etc.
RETURN TO OPENING/MAIN PAGE
LEDSaurus (on-site LED Mini Mart)



This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.